CORTEXA
← Browse
arxiveess.SY2026-07-08

Quantifying Implicit Overload Mandates in Phase Jump Requirements for Grid Forming Inverters

M A Awal, Rahul Chakraborty, David Michaud, Mikko Qvintus, Devin Dilley

Grid codes increasingly require grid-forming (GFM) inverters to demonstrate prescribed active-power response to phase-angle jumps at the point of interconnection (POI). This paper shows that such requirements embed an implicit current-overload mandate whose severity depends on the test parameters but is nowhere made explicit in the specifications. First, an analytic expression for the instantaneous power is derived at an arbitrary measurement point, establishing that a momentary power excursion in the non-opposing direction is an inevitable physical consequence of the phase jump itself, independent of control action. Second, the phase-jump recovery is formulated as a constrained optimal control problem with the characteristic GFM objective of minimizing terminal voltage deviation from the pre-disturbance value while subject to a hard current limit. As the plant dynamics are linear and the constraints are convex, the solution constitutes a controller-architecture-independent physical bound on the achievable power-recovery trajectory. Sweeping the current limit, the phase-jump acceptance criterion is converted into an equivalent minimum overload ratio, making the implicit hardware mandate quantitative. The bound is validated against three WECC generic GFM inverter models (REGFM_A1, B1, C1) in electromagnetic transient simulations, confirming both validity and tightness of the bound. Recommendations are offered for interpreting compliance test results and for structuring test specifications to distinguish physical hardware limitations from control deficiencies.

View free PDFSource page

Related papers

arxiveess.SY2026-07-10

Structural Decoupling and Current-Angle Steering for Post-Fault Recovery of Current-Limited Grid-Forming Inverters

Neethu Sajeev, Stephen Arinze Obi, Jae-Jung Jung

Reliable fault recovery of grid-forming (GFM) converters under current-limited conditions is increasingly important as inverter-based resources replace synchronous generation. Existing current-limiting strategies primarily focus on current-angle regulation and synchronization tra…

View free PDFSource page
arxiveess.SY2026-07-18

Cluster-Based Distributed Small-Signal Stability Certificates for Grid-Forming Inverter Networks

Bhathiya Rathnayake, Sijia Geng

Large-scale power networks are often organized by geography, ownership, or control authority, making stability certificates that require a fully assembled global model challenging. This paper develops a time-domain small-signal stability certification framework for grid-forming i…

View free PDFSource page
arxiveess.SYcs.AI2026-07-19

A Phased Development Framework Enabling Islanded Operation of Sustainable AI Data Centers With Onsite Grid-Following and Grid-Forming Energy Architectures

Soham Ghosh, Nabil Mohammed, Mohammad Ashraf Hossain Sadi

As hyperscale and colocation AI data centers continue to expand, the electric grid is increasingly required to support large, concentrated loads, with individual facilities ranging from 500 MW to 2 GW. Current projections estimate that approximately 50 GW of AI data center capaci…

View free PDFSource page
arxiveess.SY2026-07-14

Stability Analysis of Grid-Following and Grid-Forming Converters Connected to Generators

Alessandra Casiraghi, Marzio Barresi, Samuele Grillo

This work presents an examination of the main interactions between grid-following (GFL) and grid-forming (GFM) voltage source converters (VSCs) and synchronous generators (SGs), capturing the dynamics of a real power grid and pointing out the limitations of considering an ideal o…

View free PDFSource page
arxiveess.SY2026-07-17

Global Survey of Technologies and Industrial Applications of Grid Forming Energy Storage Systems

Heng Wu, Changjiang Zhan, Jiacheng Li, Xiaoyao Zhou, Xiongfei Wang

Grid-forming (GFM) energy storage system (ESS) is a key enabler for stabilizing future power systems with high penetration of converter-based resources (CBRs). To get a better overview of the state-of-the-art and challenges for implementing and deploying GFM-ESS, a global survey…

View free PDFSource page
arxiveess.SY2026-07-24

Physics-Informed Neural Network for Modeling the Dynamic Behavior of Grid-Forming Converters

Hussein Jaffal, Arianna Fois, Sarra Bouchkati, Amirali Mahjoob, Andreas Ulbig

This paper investigates physics-informed neural networks for modeling the full dynamic behavior of droop-controlled grid-forming converters. The approach is trained on synthetic data generated via numerical solvers and benchmarked against both traditional integration methods and…

View free PDFSource page